Wire Antennas—Beyond the Dipole (2024)

The oldest radio antenna is—guess what—a dipole. In fact, adipole was used by Professor Hertz to discover electromagnetic waves in 1886. Howdid he decide to use a dipole? After all, the first edition of the ARRLAntenna Book wasn’t printed for another 53 years!

As it turns out, a vibrating guitar string and a dipole havea lot in common. On their fundamental frequency, they are one-halfwavelength long and very efficient at responding to and generating (or radiating)energy as sound or radio waves. Hertz “plucked” or excited his dipolewith a spark and it radiated waves at around 70 MHz. An identical dipole acrossthe lab picked up those waves and developed a small arc across its terminals,the first case of RFI!

Dipole Refresher

So useful and basic, the dipole is the building block fornearly all antennas used by amateurs in one form or another. With a feed lineattached in the middle, it is easy to excite with electromagnetic energy and itreceives signals just as well. The dipole delivers about the best “bang for thebuck” in radio!

When the length of the dipole is ½ λ (one-half wavelength, withthe Greek letter lambda, λ, being the symbol for wavelength), the dipole is resonanton its lowest or fundamental resonant frequency. At this frequency, the currenton the dipole is all in the same direction but reverses its direction from onehalf-cycle to the next. Just flip the figure below horizontally around itscenter to see the dipole at work. The feed point impedance at the midpointwhere current is high and voltage low is a good match to coaxial cable, aswell.

Wire Antennas—Beyond the Dipole (1)

The current oscillating back and forth radiates energy awayas radio waves that are strongest broadside to the current. This creates thefamiliar figure-8 pattern that shows the strength of the signal in variousdirections from a dipole being excited on its fundamental.

Wire Antennas—Beyond the Dipole (2)

With more than one dipole radiating energy, the signals addand subtract, reinforcing the signal in some directions and canceling inothers. This creates gain in some directions called lobes, and creates minima, or nulls, in others. By using the half-wavedipole as a building block, called an element,we can arrange thedipoles so they create some very useful patterns.

Many arrangements of dipoles were invented long before therotatable beam, and several are still very popular today. Generally referred toas wire antennas, Hams love the various designs for their affordabilityand performance. We’ll explore a few common examples in terms of the dipoleelements from which they are constructed.

Dipoles Used on Harmonics

The simplest wire antenna beyond the half-wave dipole is to just use it on one of its odd harmonics. For example, a 40 meter dipole can be used on 15 meters, too. It’s like three half-wave dipoles connected together, end to end. As you can see in the figure, the “middle” dipole element (B) has its current maximum at the same point (but out of phase with A and C) so it provides a low SWR on that band, as well. (The resonant frequency is a little higher than three times the fundamental, but it’s still quite useable.) The pattern has a lot of lobes because the signals from the three end-to-end elements add and subtract at different angles.

Wire Antennas—Beyond the Dipole (3)

The Extended Double Zepp and G5RV

Taking the end-to-end dipole a little further, we can make agreat multi-band antenna. Start with a dipole fed at one end; this was originallyknown as the “Zepp” and today as the “End-Fed Half-Wave.” Then add a seconddipole in line with and right next to it; this is a colinear arraycalled the “Double Zepp.” If the two dipoles are fed with one feed line, theyare out-of-phase so the radiation pattern looks like a cloverleaf. However, ifyou move the dipoles apart, the single broadside lobe can reappear.

To feed the dipoles with one feed line so they are in-phase but separated, a center section is used—imagine our third-harmonic dipole with its center section pulled partially into a parallel-conductor feed line as shown in the figure below. If each side of the remaining antenna is about 5/8-λ long, this creates the “Extended Double Zepp or EDZ. The length of the feed line also performs an interesting transmission line trick and creates a 50-ohm point where coax can be attached. With an antenna tuner, you can use this antenna as a dipole on the bands below the fundamental and as a colinear array of sorts on the higher bands.

Wire Antennas—Beyond the Dipole (4)

The 8JK Array

If the end-to-end dipoles create a multi-lobed pattern, whatabout dipoles arranged side-to-side? In fact, two dipoles close together canmake a very useful pattern. Back in the 1930s, antenna designer and professorJohn Kraus, W8JK, knew that signals radiated at high vertical angles weren’t ofmuch use for working DX, but that was where dipoles low to the ground radiatedmost of their signals. He came up with the bright idea to feed two horizontaldipoles with signals out-of-phase so that directly broadside to them—straightup—the radiated signals would cancel. The horizontal separation keeps thesignals from canceling in plane of the dipoles, resulting in plenty ofDX-friendly, low-angle radiation. This is called an endfire arraybecause the maximum radiation of the antenna is in the plane of the elements.

Wire Antennas—Beyond the Dipole (5)

The Lazy H

The 8JK can be turned on its side, creating another useful and popular antenna, the Lazy H. As the figure shows, the plane of the dipole elements is vertical. This pair of dipoles is fed in-phase so the signals broadside to the array add together. Depending on the vertical separation, the signals partially cancel or, at ½-λ separation, completely cancel. The Lazy H requires higher vertical supports than the 8JK but is a great DX antenna. The Lazy H can be configured to perform consistently on several bands, as well. A pair of Lazy H’s at right angles to each other is a pretty effective antenna farm!

Wire Antennas—Beyond the Dipole (6)

Full-Wave Loops

We can arrange dipoles in a line or put them side by side,but what if we hooked them up in a triangle or square? This arrangement createsthe popular full-wave loop family of antennas. The simplest is made fromtwo ½-λdipoles bent so that their ends connect and make a square. This is the basicelement used to make “quad” antennas. As long as the shape is symmetrical andopen, such as a triangle or square or even curved into a circle, the pattern isabout the same, radiating best broadside to the plane of the loop. The feedpoint impedance is higher than for a dipole—typically 120 ohms or so—making ita good candidate for a quarter-wavematching transformeror Q-section made from ¼-λof feed line with the right characteristic impedance.

With the loop horizontal, on its fundamental the radiationis strongest straight up. These are sometimes referred to as “skywarmers” or“cloudburners” and are great for regional communications on the lower HF bands,such as emergency communication operating.

If the loop is longer than 1 λ, each side begins to act likemultiple dipoles with radiation patterns having multiple lobes. The loop’spattern adds all of those patterns from the individual sides to make a fairlycomplex but more-or-less omnidirectional pattern. That makes a large loop agood all-band, multi-purpose antenna, popular for Field Day and portableoperation, as well.

Wire Antennas—Beyond the Dipole (7)

Long Wires

Finally, you can just put up a piece of wire and apply powerto it, without worrying about the pattern.These “random wire” antennas are usually fed at or near one end withlow-loss parallel-conductor feed line and a tuner. If the wire length gets tobe more than 1 λ, the antenna is in the “long wire” category. These are traveling-wave antennas. Thelonger the wire, the more the radiation is concentrated in both directionsalong the wire. By arranging a pair of long wires in a V so that the signalsadd together, a “Vee beam” is created. A pair of Vee beams back to back in adiamond shape creates the famous rhombic.These take up a lot of real estate and require tall supports but developan excellent pattern for DX operation. In fact, the ARRL’s symbol is therhombic’s diamond!

Resources

Obviously, I’ve just scratched the surface of what you can do with some wire and a little ingenuity. If you’d like to learn more about wire antennas, there is lots of material in the ARRL Antenna Book, as well as the ARRL’s three-volume Wire Antenna Classics and multi-volume Antenna Compendium series. The RSGB’s Practical Wire Antennas by G3BDQ is a great introduction to wire antennas. (It’s out of print but available used.) And you’re sure to enjoy the late W4RNL’s article “My Top Five Multi-Band Backyard Wire HF Antennas.”

The simple “wire-in-the-trees” is where radio got its start,and those “skyhooks” are still going strong today!

Graphics courtesy ofthe American Radio Relay League

Wire Antennas—Beyond the Dipole (2024)
Top Articles
Latest Posts
Recommended Articles
Article information

Author: Kerri Lueilwitz

Last Updated:

Views: 6199

Rating: 4.7 / 5 (47 voted)

Reviews: 86% of readers found this page helpful

Author information

Name: Kerri Lueilwitz

Birthday: 1992-10-31

Address: Suite 878 3699 Chantelle Roads, Colebury, NC 68599

Phone: +6111989609516

Job: Chief Farming Manager

Hobby: Mycology, Stone skipping, Dowsing, Whittling, Taxidermy, Sand art, Roller skating

Introduction: My name is Kerri Lueilwitz, I am a courageous, gentle, quaint, thankful, outstanding, brave, vast person who loves writing and wants to share my knowledge and understanding with you.